6.2/6.5 GM
Cummins Power
Duramax Parts
Duramax Performance
Fuel Treatments
Gauges and Mounts
Kennedy Custom
Powerstroke
Suspension
Transmission
Truck Accessories
Order Amsoil Products
Return Policy
Check Order
Or enter a keyword
View My Cart


Item Name: Fuel Filter Restriction/Lift Pump Psi Gauge Kit for Duramax
Category: Duramax Parts
Sub-Category: Tools - Dmax Parts
Price: $150.00
Image

Gauge use notes:

The Duramax engine has a factory installed test port alongside the alternator. Simply remove the cap and snap my gauge onto this port and start engine. It is important to establish a baseline with clean filter(s) a full tank of fuel and on level ground. This eliminates variables in effort required to move fuel. Restriction can be checked at idle speeds and at 2-3,000 RPM. Typically we will see approximately 2-3"hg at idle with very little variance as RPM increases. As a filter loads up, you will see restriction increase. When you hit about 5-6" hg (2" above baseline) I consider the filter well used and due for replacement. The early Dmax single layer media filters would run a long time without much of an increase in restriction. The latest dual media units seem to be doing a much better job of collecting dirt, but start at a higher restriction that rises quickly as they load up. Having this gauge on hand allows you to quickly and easily verify the condition and can be very beneficial when diagnosing fuel system related drivability issues. Typical OE filter life is < 15,000 miles. We have seen these filters load as early as 2500 miles or less depending on fuel quality.

Note:

This is a flow checked device much like a compression tester. It will retain it's last reading unless the valve core is depressed. Additionally, the gauge housing is liquid filled so temperature/pressure changes can affect the zero point. There is a plug on the back of the gauge head that can be vented to allow equalization between the gauge and atmosphere, but be careful not to let the glycerin run out.